Tuesday, 08 February 2022 / Published in Flex Updates, Updates SW

New Bench solutions for Nissan Electric

Flex version 6.3.0.0 is ready

The list of electric vehicles supported by Flex has grown. The latest update released by Magicmotorsport brings new bench mode reprogramming solutions for EVCU modules on first and second generation Nissan Leafs and e-NV200 vehicles.

The new Bench protocol allows the complete reading and writing of the flash memory and the internal EEPROM.

This allows for unlimited tuning and repair possibilities for these electronic units. The entire procedure is carried out without the need to open the control unit: just follow the Flex connection manual to connect safely and effectively.

Here are the supported vehicles:

Nissan Leaf ZE1 MY2019
Nissan Leaf ZE0 MY2014
Nissan e-NV200 MY2020

The new Bench protocol is available for the following software packages:

FLS0.1 – SW Flex ECU (car, van, bike) OBD + Bench
FLS0.5 – FULL Flex package
FLS0.6 – SW Flex Renesas SH7xxxx

Read time: ~ 2 minutes | Write time: ~ 40 seconds

New protocols added:

Nissan Denso 23740-5Sxxx Gen2 SH72530: Read / Write / Checksum Internal Flash, Read / Write Internal EEPROM, Full Read / Full Write Clone / Restore
Nissan Denso 23740-5Sxxx Gen2 SH72531: Read / Write / Checksum Internal Flash, Read / Write Internal EEPROM, Full Read / Full Write Clone / Restore
Nissan Denso 23740-3Nxxx Gen1 SH72531: Read / Write / Checksum Internal Flash, Read / Write Internal EEPROM, Full Read / Full Write Clone / Restore

Software Improvements: